top of page
Search

How to check HPFP rail pressure in a datalog (requested vs actual)

Writer: Vancea Ovidiu
Vancea Ovidiu
8 hours ago
2 min read

The quickest way to know if your fuel system is enough for your tune is a datalog of one full-throttle pull. It shows in minutes whether the high-pressure fuel pump (HPFP) keeps up.

What to log

  • Requested (specified) fuel rail pressure

  • Actual fuel rail pressure

  • Engine speed (rpm) and engine load

How to do the pull

  • Warm engine, on a dyno or a safe closed road

  • 3rd or 4th gear, full throttle from low rpm all the way to the rev limit

  • Repeat it two or three times so you can compare the runs

How to read it

Actual pressure should follow the requested pressure closely all the way to the rev limit. If it falls away as rpm rises, the pump is at its limit. On a car you often feel the same thing: power falls off at high rpm, or the fuel cuts in the midrange.

Before you blame the pump, rule out the simple causes: a weak low-pressure supply from the tank pump, or on the EA113 a worn cam follower.

What a VIS kit changes

A VIS kit fits a larger piston in your original pump, so every stroke delivers more fuel:

Send us your log

Send the log to your tuner, or to us on WhatsApp (+40 740 310 235) or at contact@vismotorsport.com, and we will tell you whether an upgraded pump makes sense.

 
 
 

Comments


VIS MOTORSPORT

SC OVIS MOTORSPORT SRL

Str. Crinului 35, Nojorid, Bihor 417345, Romania

CUI RO36841373 · CAEN 4791 (Rev. 3)

Nr. Reg. Com. J2016002195055

EUID ROONRC.J2016002195055

Tel/WhatsApp: +40 740 310 235

​contact@vismotorsport.com

VIS Motorsport on Instagram
VIS Motorsport on Facebook
Chat with VIS Motorsport on WhatsApp
VIS Motorsport on TikTok
Accepted payment methods at VIS Motorsport
ANPC SAL – alternative dispute resolution for consumers

© 2016–2026 SC OVIS MOTORSPORT SRL · VIS Motorsport · All rights reserved

bottom of page