Installing an HPFP upgrade kit: tools, steps and checks
A VIS HPFP kit replaces the piston and sleeve inside your original high-pressure fuel pump. The pump body, sensors and valves stay. Most of the job is removing the pump, swapping the internals and refitting it.
Before you start
Use an original Hitachi / Hucho / Astemo pump body. Aftermarket pumps (for example Pierburg) are not recommended for the kit.
Work on a cold engine, with the battery disconnected and the fuel pressure released, as described in the service manual.
Prepare a clean bench. Dirt inside a high-pressure pump causes wear.
Have new seals ready (a Viton pump O-ring comes with the kit), a torque wrench and the installation instructions for your kit.
The job, step by step
Release the fuel pressure and remove the pump from the engine.
Remove the sensors and valves fitted to the pump body so they are not damaged.
Take out the original spring, piston and seal housing, then clean the pump body.
Fit the VIS piston and sleeve exactly as the kit instructions describe. Never force a part in.
On cam-driven pumps, inspect the cam follower and replace it if it is worn. This matters most on the EA113: a worn follower damages the camshaft lobe and the pump.
Refit the pump with new seals and tighten everything to factory torque.
After fitting
Check for fuel leaks at idle and again after the first drive.
Log requested and actual rail pressure on a full-throttle pull. Our guide shows how to check rail pressure in a datalog.
Send the log to your tuner, or to us on WhatsApp, if anything looks wrong.
Prefer not to do it yourself?
Send us your pump. With our HPFP rebuild service we clean it ultrasonically, inspect every part, fit your VIS kit, test it and ship it back in 3–5 working days.
See all VIS HPFP kits or send us your engine code and we will tell you which kit fits.




Comments